Albertosaurus Fossil range: Late Cretaceous, 71(possibly 76.6)-67 Ma | |
---|---|
Artist's restoration of Albertosaurus. | |
Scientific classification
| |
Class |
|
Superorder |
|
Order |
|
Suborder |
|
Family |
|
Genus |
|
|
Albertosaurus (meaning "Alberta lizard") is a genus of tyrannosaurid theropod dinosaur that lived in western North America during the Late Cretaceous Period, more than 70 million years ago. The type species, A. sarcophagus, was restricted in range to the modern-day Canadian province of Alberta, after which the genus is named. Scientists disagree on the content of the genus, with some recognizing Gorgosaurus libratus as a second species.
As a tyrannosaurid, Albertosaurus was a bipedal predator with tiny, two-fingered hands and a massive head with dozens of large, sharp teeth. It may have been at the top of the food chain in its local ecosystem. Although relatively large for a theropod, Albertosaurus was much smaller than its more famous relative Tyrannosaurus, probably weighing less than 2 metric tons.
Fossils of more than thirty individuals have been recovered, providing scientists with a more detailed knowledge of Albertosaurus anatomy than is available for most other tyrannosaurids. The discovery of 22 individuals at one site provides evidence of pack behavior and allows studies of ontogeny and population biology which are impossible with lesser-known dinosaurs.
Description[]
Albertosaurus was smaller than some other tyrannosaurids, such as Tarbosaurus and Tyrannosaurus. Typical adults of Albertosaurus measured up to 9 metres (30 feet) long, while rare individuals of great age could grow to over 10 metres (33 feet) in length. Several independent mass estimates, obtained by different methods, suggest that an adult Albertosaurus weighed between 1.3 tonnes (1.4 short tons) and 1.7 tonnes (1.9 tons).
All tyrannosaurids, including Albertosaurus, shared a similar body appearance. Typically for a theropod, Albertosaurus was bipedal and balanced the heavy head and torso with a long tail. However, tyrannosaurid forelimbs were extremely small for their body size and retained only two digits. The hind limbs were long and ended in a four-toed foot. The first digit, called the hallux, was short and only the other three contacted the ground, with the third (middle) digit longer than the rest. Albertosaurus may have been able to reach walking speeds of 14−21 kilometres per hour (8−13 miles per hour). At least for the younger individuals, a high running speed is plausible.
Skull and teeth[]
The massive skull of Albertosaurus, perched on a short, S-shaped neck, was approximately 1 metre (3.3 feet) long in the largest adults. Wide openings in the skull (fenestrae) reduced the weight of the head while also providing space for muscle attachment and sensory organs. Its long jaws contained, both sides combined, 58 or more banana-shaped teeth; larger tyrannosaurids possessed fewer teeth, Gorgosaurus at least sixty-two. Unlike most theropods, Albertosaurus and other tyrannosaurids were heterodont, with teeth of different forms depending on their position in the mouth. The premaxillary teeth at the tip of the upper jaw, four per side, were much smaller than the rest, more closely packed, and D-shaped in cross section. Like with Tyrannosaurus, the maxillary (cheek) teeth of Albertosaurus were adapted in general form to resist lateral forces exerted by a struggling prey. The bite force of Albertosaurus was less formidable however, the maximum force, by the hind teeth, reaching 3,413 Newton. Above the eyes were short bony crests that may have been brightly coloured in life and used in courtship to attract a mate.
William Abler observed in 2001 that Albertosaurus tooth serrations resemble a crack in the tooth ending in a round void called an ampulla. Tyrannosaurid teeth were used as holdfasts for pulling meat off a body, so when a tyrannosaur pulled back on a piece of meat, the tension could cause a purely crack-like serration to spread through the tooth. However, the presence of the ampulla distributed these forces over a larger surface area, and lessened the risk of damage to the tooth under strain. The presence of incisions ending in voids has parallels in human engineering. Guitar makers use incisions ending in voids to, as Abler describes, "impart alternating regions of flexibility and rigidity" to the wood they work with. The use of a drill to create an "ampulla" of sorts and prevent the propagation of cracks through material is also used to protect aircraft surfaces. Abler demonstrated that a plexiglass bar with incisions called "kerfs" and drilled holes was more than 25% stronger than one with only regularly placed incisions. Unlike tyrannosaurs, ancient predators like phytosaurs and Dimetrodon had no adaptations to prevent the crack-like serrations of their teeth from spreading when subjected to the forces of feeding.
Classification and systematics[]
Albertosaurus is a member of the theropod family Tyrannosauridae, in the subfamily Albertosaurinae. Its closest relative is the slightly older Gorgosaurus libratus (sometimes called Albertosaurus libratus; see below). These two species are the only described albertosaurines; other undescribed species may exist. Thomas Holtz found Appalachiosaurus to be an albertosaurine in 2004, but his more recent unpublished work locates it just outside Tyrannosauridae, in agreement with other authors.
The other major subfamily of tyrannosaurids is the Tyrannosaurinae, including Daspletosaurus, Tarbosaurus, and Tyrannosaurus. Compared with these robust tyrannosaurines, albertosaurines had slender builds, with proportionately smaller skulls and longer bones of the lower leg (tibia) and feet (metatarsals and phalanges).
Below is the cladogram of Tyrannosauridae based on the phylogenetic analysis conducted by Loewen et al. in 2013.
Tyrannosauridae |
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||